Hangar 9 J-3 Cub 1/4 Scale Spares / Parts

Center the 3mm washers to secure the wing to the hatch. If at any time while operating your model you sense any In addition to the items needed to run the Blackjack 55, we abnormal function, end your operation immediately. Warranty And Repair Policy m 4. Charge it up, launch it into the water, and get ready to have hours of fun on the smallest body of water. General Guidelines If at any time while operating your model you sense any In addition to the items needed to run the Blackjack 55, we abnormal function, end your operation immediately. You can also purchase them from Horizon Hobby by calling or shop online www.

Produits Recommandés

Menu de navigation

The box should contain the Blackjack 55 and a Section 8: If you are missing any of these items or notice any Section 9: If at any time while operating your model you sense any In addition to the items needed to run the Blackjack 55, we abnormal function, end your operation immediately.

Do not recommend that you carry the following in your field box: There are 4 plywood boat stand pieces. The 2 short plywood pieces are the ends of the boat stand. Remove the ten 2. Installing the Wing Section 6: Installing the Rudders m 1. Install the wing in the direction shown.

Use two 3mm x 12mm sheet metal screws and two m1. Turn on the transmitter, then the receiver. Center the 3mm washers to secure the wing to the hatch. Fill the tank Note: The Zenoah G26M carburetor completely and secure the fuel cap.

Keep fuel in a moisture Choking the Engine Section Close the choke by rotating the small yellow tubing extension. Stopping the Engine This is not necessary if the engine is warm.

Idle the boat near shore and press the kill switch located on the hull as shown. Pull-starting the Engine Section With an assistant holding the boat to the boat Cooling System Water Pump m The centrifugal clutch automatically engages when the engine rpm is increased.

This warranty does not cover any parts damaged by use or modification. Further, Horizon Hobby reserves the right to change or modify this warranty without notice. There are 4 plywood pieces. The 2 short plywood pieces are the ends of the boat stand. Attach the 2 long plywood pieces of the interlocking boat stand to one end of the short plywood pieces.

Remove the knurled aluminum nut that dry cell battery holder. Likewise, the boat of fresh batteries. If everything appears to be operating The engine and special three blade propeller have been designed to give your Vortex 46 optimum performance. The high-speed and low-speed needle valves control Start your engine and advance the throttle to full, the ratio of fuel to air that the engine receives.

If then pinch the fuel line going to the engine. Glow plug failed due to lean engine setting: Vortex 46 Replacement Parts In the event that you need to purchase replacement parts for your engine or the Vortex 46 please see your local hobby store. You can also purchase them from Horizon Hobby by calling or shop online www.

Appendix Engine and fuel line installation viewed from top. Charge it up, launch it into the water, and get ready to have hours of fun on the smallest body of water. At the pool, lake or pond, it's fun wherever you go. The Blackjack 9 catamaran features a competition folding trim scheme. This twin-hulled beauty slices through the surface and stands out from the rest. This boat section is divided into Ready to Run boats, and Boat Kits that need assembly.

This is just a sample of the many manufacturers we carry as well as additional kits and parts. If you do not see what you want here, please call us to find out about our huge inventory and great prices! Please note that international, oversize and multiple orders are subject to additional shipping cost.

PLASTIC KITS

Leave a Reply